[Free] 2018(May) EnsurePass Passguide VMware VCPC550 Dumps with VCE and PDF 21-30

Ensurepass.com : Ensure you pass the IT Exams
2018 May VMware Official New Released VCPC550
100% Free Download! 100% Pass Guaranteed!

VMware Certified Professional – Cloud(vCloud Automation Center

Question No: 21

An administrator determines that when a host residing in a High Availability (HA)

cluster fails, the virtual machines fail to restart on a remaining host, or will only restart after a long delay.

Which two conditions would account for this behavior? (Choose two.)

  1. The virtual machines were not protected by vSphere HA at the time the failure occurred.

  2. Distributed Resource Scheduler was not enabled at the time the failure occurred.

  3. There is insufficient spare capacity on hosts with which the virtual machines are compatible.

  4. The virtual machines contain physical Raw Device Mappings.

Answer: A,C

Question No: 22

An administrator of a secure environment needs to add an iSCSI target to a new ESXi host using the vSphere client. The administrator has configured discovery and performed a rescan operation, but the iSCSI target does NOT appear.

Which action should the administrator take for the target to appear in the vSphere client?

  1. Configure appropriate CHAP authentication settings

  2. Bind a VMkernel port to the iSCSI initiator

  3. Configure Jumbo Frames prior to adding iSCSI targets

  4. Enable iSCSI in a vSphere Distributed Switch configuration

Answer: A

Question No: 23

What should an administrator do to identify compliance for virtual machine storage performance?

  1. Create a Storage Policy and apply it to the virtual machine

  2. Create Storage Capabilities and apply one or more capabilities to the virtual machine

  3. Create a Storage Policy and apply it to the datastore containing the virtual machine

  4. Create Storage Capabilities and apply one or more capabilities to the datastore containing the virtual machine

Answer: A

Question No: 24

An administrator is installing ESXi 5.x to a local SAS drive.The installation stops on a purple screen and shows the error:

The system has found a problem on your machine and cannot continue. Could not populate the filesystem: Admission check failed

Which action should the administrator take to resolve this issue?

  1. Upgrade the ESXi host to meet the minimum hardware requirement for installation.

  2. Disable the network interface cards (NICs) to ensure that third-party drivers do not interfere with installation.

  3. Enable hardware Virtualization Technology in the ESXi host BIOS.

  4. Disable the Host Bus Adapters (HBA) to ensure the installation targets the local disk.

Answer: A

Question No: 25

A vSphere administrator is attempting to migrate a virtual machine, but the progress bar for the migration remains at 10%.

Which issue could be preventing the vMotion migration?

  1. A networking problem between the source and destination hosts exists at the physical layer.

  2. The virtual machine is not on shared storage visible to the source and destination hosts.

  3. The vMotion migration priority for this migration was set to High.

  4. The vMotion network is saturated.

Answer: A

Question No: 26

An administrator needs to configure vFlash Read Cache to improve performance. What would benefit the most from enabling vFlash Read Cache?

  1. Virtual machines replicated with vSphere Replication

  2. Web Server virtual machines

  3. Database virtual machines

  4. Virtual machines migrated using Storage vMotion

Answer: B

Question No: 27

An administrator is deploying vSphere 5.5.The administrator creates a vSphere Distributed Switch, then uses Auto Deploy to deploy several ESXi hosts. After the hosts are deployed, the administrator notices that LACP packets are NOT being sent between them.

Which condition would cause this issue to occur?

  1. The LACP support settings do NOT exist in the Host Profile.

  2. The LACP installation bundle is NOT included in the Image Profile.

  3. LACP is NOT enabled on vCenter.

  4. LACP has NOT been configured on the Auto Deploy server.

Answer: A

Question No: 28

An administrator needs to establish that a database server is entitled to twice the CPU resources compared to a web server during CPU resource contention.

Which settings should the administrator change to accomplish this?

  1. Set the database server#39;s CPU Shares to High and leave the web server#39;s CPU Shares at Normal.

  2. Set the database server#39;s CPU Shares to High and change the web server#39;s CPU Shares to Low.

  3. Set the database server#39;s CPU Shares to High and change the web server#39;s CPU Shares value to a Custom value of 500.

  4. Set the database server#39;s CPU Shares to a Custom value of 500 and leave the web server#39;s CPU Shares at Normal.

Answer: A

Question No: 29

An administrator is deploying vSphere using a NAS device as the shared storage system. The administrator has already created a VMkernel port, enabled the NFS client, and configured a mount point accessible to the hosts.

Which additional configuration is required before the datastore can be used to create virtual machines?

  1. The ESXi hosts must have root access to the datastore.

  2. The NAS must support NFS version 4.

  3. Port binding must be configured on the VMkernel port.

  4. The MTU on the VMkernel port must be set to 9000.

Answer: A

Question No: 30

A vSphere administrator can create an alarm on which two objects? (Choose two.)

  1. LUN

  2. Datastore

  3. Template

  4. Folder

Answer: B,D

100% Ensurepass Free Download!
Download Free Demo:VCPC550 Demo PDF
100% Ensurepass Free Guaranteed!
Download 2018 EnsurePass VCPC550 Full Exam PDF and VCE

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

Your email address will not be published. Required fields are marked *