Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 400-101
100% Free Download! 100% Pass Guaranteed!
CCIE Routing and Switching (v5.1)
Question No: 221 DRAG DROP – (Topic 2)
Drag and drop each step in the performance-monitoring configuration process on the left into the correct order on the right.
Answer:
Question No: 222 – (Topic 2)
What are the two BFD modes? quot;(Choose two)
-
active
-
asynchronous
-
C. passive
-
established
-
demand
-
synchronous
Answer: B,E
Question No: 223 – (Topic 2)
Refer to exhibit. Which statement about the 192.168.100.0/24 destination network is true?
-
The Reported distance for the Successor is 128256
-
The metric installed into the route tabel is 4352
-
The metric installed into the route table is 126256
-
The Reported Distance for the Feasible Successor is 409600
Answer: A
Explanation: QUESTN 55
which two statements are true about an EVPL? (Choose two ) A.it does not allow for service multiplexing
B.It has a high degree of transparency
C.The EVPL service is also referred to as E-line
D.It is a point-to-point Ethernet connection between a pair 01UNls
Answer: CD
Question No: 224 – (Topic 2)
Which two statement about VPLS are true? (Choose two)
-
Split horizon is used on PE devices to prevent loops.
-
IP is used to switch Ethernet frames between sites.
-
Spanning tree is extended from CE to CE
-
VPLS extends a layer 2 broadcast domain.
-
PE routers dynamic associate to peers.
Answer: A,D
Question No: 225 – (Topic 2)
Which statement describes Cisco PfR link group?
-
Link groups enable Cisco PfR Fast Reroute when NwtFlow is enabled on the external interfaces of the border routers.
-
Link groups define a strict or loose hop-by-hop path preference.
-
Link groups are required only when Cisco PfR is configured to load-balance all traffic.
-
Link groups are enabled automatically when Cisco PfR is in Fast Reroute mode.
-
Link groups set a preference for primary and fallback (backup) external exit interfaces.
Answer: E
Question No: 226 – (Topic 2)
Refer to the exhibit.
When you apply these configurations to R1 and R2. which two effects occur? (Choose two)
-
The 172.16.1.1 network is reachable via OSPF on R1
-
RI authenticates using the username Cisco
-
C. R1 and R2 successfully authenticates using CHAP
-
Authentication between R1 and R2 fails.
-
R1 and R2 authentications using PAP
Answer: B,D
Question No: 227 – (Topic 2)
Refer to the exhibit.
Which additional configuration statement is required on R3 in order to allow multicast traffic sourced from 192.168.13.3 to flow along the shared-tree?
A. ip route 192.168.14.0 255.255.255.0 Tunnel 0
B. ip route 10.4.4.4 255.255255.255 Tunnel 0
C. ip mroute 10.4.4.4 255.255.255.255 Tunnel 0
D. ip mroute 192.168.14.0 255.255.255.0 Tunnel 0
Answer: C
Question No: 228 – (Topic 2)
What are the three variants of NTPv4? (Choose three.)
-
client/server
-
broadcast
-
symmetric
-
multicast
-
asymmetric
-
unicast
Answer: A,B,C
Question No: 229 – (Topic 2)
According to the networking best practices .which network device should be used for optimization and rate limiting?
-
the provider core device
-
the provider edge device
-
the customer core device
-
the coustomer edge device
Answer: D
Question No: 230 – (Topic 2)
Which IPv4 feature prevents multicast joins on a per-port basis?
-
MLD filtering
-
IGMP filtering
-
IGMP snooping
-
PIM snooping
Answer: B
100% Ensurepass Free Download!
–400-101 PDF
100% Ensurepass Free Guaranteed!
–400-101 Dumps
EnsurePass | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |